problem was that with dd-wrt.v24-15230_NEWD_micro-plus_ssh
my android phone could not obtain IP address via DHCP (dd-wrt show that it assigned an IP but it did not detect any hostname for my phone)
so I upgraded to dd-wrt.v24-15508_NEWD_micro-plus_ssh
and everything works fine
what do i need to do if i installed the VXWorks-killer-new and it rebooted and now the power emblem doesnt light and i cant go on the site to update it with the Micro generic
what do i need to do if i installed the VXWorks-killer-new and it rebooted and now the power emblem doesnt light and i cant go on the site to update it with the Micro generic
Posted: Sat Feb 12, 2011 19:26 Post subject: Question before diving off the deep end
Hi,
I'm considering flashing my WRT54G2 V1 (firmware 1.0.01) as described on the "hardware specific wiki" http://www.dd-wrt.com/wiki/index.php/Linksys_WRT54G2
Before I do however, I was wondering if anyone could tell me if I still risk bricking on the hard (30-30-30) reset?
From what I gathered up till now these routers were very suceptible to bricking on 30-30-30 reset, but there was a workaround.
So now I'm wondering if the workaround has been implemented in the provided firmware/bin somehow?
I realize that this information can probably be found somwhere in this topic, but I'm way to impatient to read through 76 pages of posts to find out.
So I tought i'd just ask...
Thanks in advance,
Reech.
Edit:
Scratch the above.
I went ahead and tried it, and except for 1 close call (Mixed up the router name with an other one) I've got it running with v24-sp2 micro build 10709 NEWD (by Eko).
I'm still stuck with 1 question however.
The hardware specific page, as well as the peacock thread, advise to upgrade asap.
But they're not recomending the same build.
Which build is recommended for my router and where can I find it?