Thanks for the advice, I'll look at the other distro's.
I'm on the latest version for this device, according to the availability listing (13064). I don't see any diff in the hardware between the 1650 and 2610, but it's possible that screen is somehow hardware dependent. I just don't have that menu, so I'm not sure if the stuff I do in the Networking tab with tags & bridges will take effect- I can't make it work so far...
MichelG wrote:
Upgrade to the latest firmware version.
Look into Other, Eko, BrainSlayer Pre-SP2, and then the latest firmware available, EOC-1650.
On my EOC-2610, I have a tab named Networking, with VLAN , TAG, etc.
Yes, the wiki has a massive amount of info, though there haven't been any posts spot on with using wrt as a pure bridge, with a management interface in the fashion I'm trying.
Been trying different combo, but there are conflicting pieces of info in various tutorials, then trying to make a Linksys doc apply to a single ethernet unit, and the bridges, physical, and logical interfaces mated with the right vlan tags. UG!