Posted: Tue May 11, 2010 2:37 Post subject: SENAO EOC-2610 (Bricked)
Hello
I have an Access Point EOC-2610 model, which will install the DD-WRT firmware, but I was not consistent with the performance.
So you work to load the original firmware again and my device is Briked.
I can not access the boot loader or to reboot because the only Power Led is On.
all other lights stay off, does not give ip address and connecting to the LAN port does not detect any activity
So I'm trying to get my device with JTAG and only image I have attached and which I managed to decipher all connections but one
In the picture you can see six wires conecctions (Blue, white, green, orange, gray and black)
Blue = Chip Select (pin 7 M25P64 Flash memory)
White = Serial Data Ouput (pin 8 of the M25P64 Flash memory)
Green = Serial Clock (pin 16 M25P64 Flash memory)
Orange = Serial Data Input (pin 15 M25P64 Flash memory)
Gray = Ground (GND PCB board)
Black = Unknown?
Can you help me how to do to get my device?
My device is based on the Atheros AR2316 CPU Chip and a model M25P64 flash memory (8MB) Serial
True, but this time the question is what is the connection or identification of the wire, not to recover the device.
I'm just asking you to help me with the jtag connections, specifically to where the black wire is connected, which is the only one that I need identified.
***** Español **************
Cierto, pero esta vez se trata de saber cual es la conexion o identificacion de los cables, no de recuperar el dispositivo.
Solo estoy pidiendo que me ayuden con las conexiones al jtag, especificamente hacia donde esta conectado el cable negro, que es el unico que me falta identificar.
Posted: Mon Jun 14, 2010 21:25 Post subject: Re: True
CiberPanare wrote:
Sash wrote:
i guess this was already discussed
True, but this time the question is what is the connection or identification of the wire, not to recover the device.
I'm just asking you to help me with the jtag connections, specifically to where the black wire is connected, which is the only one that I need identified.
***** Español **************
Cierto, pero esta vez se trata de saber cual es la conexion o identificacion de los cables, no de recuperar el dispositivo.
Solo estoy pidiendo que me ayuden con las conexiones al jtag, especificamente hacia donde esta conectado el cable negro, que es el unico que me falta identificar.
I need too the pinout jtag eoc 2610, redboot is corrupt
