Joined: 19 Mar 2008 Posts: 119 Location: Μεσοποταμία
Posted: Fri May 08, 2009 18:41 Post subject: signal disappear in cambria
hi every one
i have really strange problem
one of my Cambria boards carry 4xXR2 cards and running as AP only on B mode with MacFilter.
recently, some times (three times a week) the transmitting signal for 2 cards disappear and the users cannot see it until i reboot the router.
upgrading to the latest built didn't change anything. i though it was overheating problem since the CPU temp reaches 70 degree Centigrade. but when i told the company they told me that this board can work with this temperature without problem. any ideas ? _________________ 13 x IXP, 6 x RB532, 16 x Broadcom, 4 x NS, 4 x PS, many TP-Link
Joined: 19 Mar 2008 Posts: 119 Location: Μεσοποταμία
Posted: Sat May 09, 2009 18:37 Post subject:
ok, i replaced it with (EMP-8603 (ETSI) LFP)
but i have one question, what should i put in the TX Power for this card ? is there any recommended setting for it ? _________________ 13 x IXP, 6 x RB532, 16 x Broadcom, 4 x NS, 4 x PS, many TP-Link
Joined: 19 Mar 2008 Posts: 119 Location: Μεσοποταμία
Posted: Mon May 11, 2009 12:34 Post subject:
Sash wrote:
not full power (as low as possible) -> bigger mtbf
until now the card shows no problem, the users signal is looks better than the replaced XR2. the power of the card is set just lower than the maximum , until now the previous problem disappear. _________________ 13 x IXP, 6 x RB532, 16 x Broadcom, 4 x NS, 4 x PS, many TP-Link