Posted: Wed Sep 09, 2009 2:18 Post subject: Build 12874 - Tests and reports
Testing the Atheros / Senao 2610 version. Same issue as the broadcom, the Wiviz starts, looks for WNICs, but blocks the router, and the radio disconnects / reboots.
If we do close it, we get again access to the router (it blocks any request or traffic done to www, imap, pop, smtp, etc)
Also, seems to get very weak signal from the APs. Yesterday, I was getting around -77dB / -78dB Signal, today after the upgrade (reset to factory defaults) I get only - 82dB / -85dB and the noise remains almost the same 94/96dB
Any other feedback welcome. Thanks, Michel _________________ 2x EOC-2160 - AP 2x14dB Yagy to 450m link
2x EOC-2160 - RP 2x17dB Panels - 2x 7Mbps
1x WRT54G v2.2 - V24-SP2 13577VPN Eko
All Senao EOC-2610 V1.10 Std 15362 BS
1x UBNT Bullet 2 - RP 18dB Panel - 11Mbps - 13Km link
Superchannel disable
Tx power 15dBi
Antenna gain 0
Wireless mode Client
G Only
Noise Immunity Enabled
N. immunity level 1
OFDM Weak Detection enabled
Minimum rate = auto
Maximum rate = 36
Short Preamble Disable
Extended Range Disable
Super G Fast Framing Disable
Diversity disable
Primary
Primary
Rest is default settings. Using a VAP with WPA PSK. No issues connecting to it _________________ 2x EOC-2160 - AP 2x14dB Yagy to 450m link
2x EOC-2160 - RP 2x17dB Panels - 2x 7Mbps
1x WRT54G v2.2 - V24-SP2 13577VPN Eko
All Senao EOC-2610 V1.10 Std 15362 BS
1x UBNT Bullet 2 - RP 18dB Panel - 11Mbps - 13Km link
Hi Sash, I have had the chance to compare 2 Senao 2610, one with DD-WRT 12874, and the other with Senao 1.39 Firmware.
DD-WRT does see around 30% more WIFI APs than Senao Fw.
Also, the APs I do use have just 1Mbps/288Kbps so, it is not really an issue regarding the internet speed, it was more related to the stability and connection to the APs in mode G.
Michel _________________ 2x EOC-2160 - AP 2x14dB Yagy to 450m link
2x EOC-2160 - RP 2x17dB Panels - 2x 7Mbps
1x WRT54G v2.2 - V24-SP2 13577VPN Eko
All Senao EOC-2610 V1.10 Std 15362 BS
1x UBNT Bullet 2 - RP 18dB Panel - 11Mbps - 13Km link
As far as I remember, Repeater mode is usually related to G-only. Am I wrong ? _________________ 2x EOC-2160 - AP 2x14dB Yagy to 450m link
2x EOC-2160 - RP 2x17dB Panels - 2x 7Mbps
1x WRT54G v2.2 - V24-SP2 13577VPN Eko
All Senao EOC-2610 V1.10 Std 15362 BS
1x UBNT Bullet 2 - RP 18dB Panel - 11Mbps - 13Km link