Your reports for Ralink-based routers are highly appreciated !!
Router Model:
Status:
Reset:
Errors: _________________ THERE ARE NO STRANGERS HERE; ONLY FRIENDS YOU HAVEN'T YET MET.
________________________________________________________________________________________________________
DD-WRT CHANGELOG | DEVICES | DD-WRT BUILDS | KONG BUILDS | UNOFFICIAL BUILDS | DD-WRT in VIRTUALBOX
Last edited by KrypteX on Mon Jan 19, 2015 20:25; edited 1 time in total
- DIR-615 rev. H2
- upgrade from r25934 to r25948
- w/o 30/30/30 or reset to factory defaults
- restored previous settings
- no problems, except "Disable Wireless GUI access" still isn't working _________________ Asus RT-AC87U
DD-WRT v3.0-r36596 std
Router Model: D-Link DIR-810L B1
Status: OK
Reset: 30,30,30 or reset to factory default
Errors: wl1 (5ghz) won't work in client mode and adhoc mode. Under the "Status\Wireless" tab in web gui, wl1 shows up as a "unknown" radio state instead of saying "Radio is On" or "Radio is Off". When trying to hit the "Site Survey" button at the bottom, I get a msgbox "Not Available! Please enable Wireless network." Same thing in every Wireless Network mode (mixed, a-only, na-mixed, n-only (5ghz))
The other Wireless modes work fine though (AP mode, repeater mode, repeater bridge) and give a correct radio status. They also list some AP when doing the site Survey. wl0 (2.4ghz) is also working fine. This problem was there in the previous beta I tested (build 25815).
Router Model: Buffalo WHR-300HP2D
Status:No Wan IP
Reset:30/30/30 reset
Errors: Could not get a WAN IP assigned via DHCP, I reverted back to the 22750b DD-WRT firmware from the Buffalo website and it was able to get an IP assigned.
I have a slider switch on the router with 3 modes:
Auto
Router
Bridge