WNDR3700 V4
DD-WRT v3.0-r27858 std (09/28/15)
Linux 3.10.89 #9375 Mon Sep 28 04:00:42 CEST 2015 mips
RESET from previous - 27805
Linux 3.10.87 #9125 Fri Sep 11 03:26:26 CEST 2015 mips
Using:
DNSMasq for DHCP
DNSMasq for DNS
DHCP-Authoritative
Recursive DNS Resolving (same as previous builds, unbound.conf will NOT get local-data until 'Apply Settings')
Forced DNS Redirection
Used Domain LAN & WLAN
Local DNS
No DNS Rebind
Query DNS in Strict Order
Radios working good.
Restricted guests on a br1/ath0.1 working good.
Just the one ugly in dmesg:
<6>[ 27.610000] warning: process `unbound' used the deprecated sysctl system call with 1.40.6.
Router: TP-Link TL-WR841ND v9 (9.3)
Firmware: DD-WRT v3.0-r27858 std (09/28/15)
Kernel: Linux 3.18.21 #5229
Status: OK so far operating in router mode. Guest wireless VAP is also working normally. All Wired and Wireless clients using DHCP working fine.
Reset: No
Errors: Minor
-Needs startup command for Wired devices to see other Wired devices:
swconfig dev eth0 set enable_vlan 1
swconfig dev eth0 set apply
Router: TP-Link WDR4300 v1.2
Firmware: DD-WRT v3.0-r27858 std
Kernel: Linux DD-WRT 3.10.89 #9311 Mon Sep 28 02:49:57 CEST 2015 mips GNU/Linux
Status: 2.4 GHz and 5 GHz wifi is working
Reset: Yes, via reset switch
Errors: No 5 GHz led
Router: TP-Link tl-wr1043nd v2
Firmware: DD-WRT v3.0-r27858
Kernel: 3.18.21 #5233
Status: working as AP/samba server
Reset: no
Errors: none so far
Router: TP-Link Archer C7 v2
Firmware: DD-WRT v3.0-r27858
Kernel: 3.18.21 #5235
Status: Working as AP/samba/dlna
Reset: No
Errors: GUI didn't work initially. It required an extra reboot, then about 10 minutes to settle down. Now it seems to be OK.
Router: TP-Link tl-wr1043nd v1
Firmware: DD-WRT v3.0-r27858 std (09/28/15)
Status: ok
Reset: no
Errors: none
The only problem is not working Sys-Info tab in Status tab. Seems like info.htm is missing? The same problem was in previous build too. Pressing Sys-Info returns me to Setup -> Basic Setup.
ps. ipv6 with native ISP DHCPv6 with prefix delegation is working great!
Joined: 24 Feb 2013 Posts: 1634 Location: Belgrade
Posted: Tue Sep 29, 2015 8:21 Post subject:
iga2iga wrote:
The only problem is not working Sys-Info tab in Status tab. Seems like info.htm is missing? The same problem was in previous build too. Pressing Sys-Info returns me to Setup -> Basic Setup.
thought this feature displays info page instead of login-password prompt when entering the router IP address, does it? So why completely disable the info-page if I've alredy logged in?