The AP is telling the clients it uses WEP (not true) instead of WPA2/PSK. Windows WZCS and Linux Network Manager are not prompting for the correct encryption keys. Same thing for the Netgear WG311v3 utility.
If I set the crypto params manually, it works.
I have switched over to WEP (yuck) until this is resolved.
I think I should have bought a Broadcom based router instead of this Atheros 4 MB POS.
This problem reappeared, so I reset to default values and reconfigured for WPA2/PSK/AES. It has been working ok for the last 20 hours. Finger crossed, otherwise I will revert to factory firmware because I will NOT use WEP.
Same here -- except my Airlink AR430W says in the status and settings that it is WPA2 Personal Mixed but the client says there is no encryption at all and a number of leeches are connecting to my AP now.
Same here -- except my Airlink AR430W says in the status and settings that it is WPA2 Personal Mixed but the client says there is no encryption at all and a number of leeches are connecting to my AP now.
+1
Same thing here again after 24 hours. The DIR300 v24pre-sp2 web ui shows WPA2/PSK/AES, but the clients say there is no encryption at all. If I ssh into the DIR300 and do iwconfig, it shows that ath0 is is master mode, and that encryption is off.