Posted: Thu Feb 19, 2009 14:24 Post subject: EOC-2610 Radio Problem Connection On and Off (WDS) Mode
I just flash this EOC-2610 and purchased the activation key . The problem is It's link into WDS to another LinksysGL V24SP2 Special Edition and it's using channel 1 from 14 all got problem the wifi will on and off and it's not stable when link via WDS
I'm using SP2 version for the v24sp2 12/18/08 released. Is there any problem with it? With WDS it will loss signal on and off . Please clarify this.
Without the WDS AP mode via cable with same settings the signal is stable.
How can i revert back to SP1? Maybe SP1 is stable have to use back the bootloader tricks or just use the WEB GUI Interface?
Still trying to change channel from 1 to 7 and still having the same problem with it.
Posted: Wed Feb 25, 2009 4:41 Post subject: Problem FIX
Sash wrote:
there is no real sp1 cause we added support in october or so.
have installed the latest build now?
what wifi problems do u have?
The sp2 4MB firmware got problem. The radio showing running super G once 1 min got 54Mbps and another one is running at 150Mbps. On and off then disconnect.
So i have flash 2 EOC-2610 with the sp2 6MB firmware and it's running 24/7 stable rite now.
I figure out something while playing with it
You need to wait about 30 seconds before turning it on.Otherwise the Radio won't start properly.
Now i just need to figure out the correct settings for EXT Antenna not sure firmware bug or TX and RX settings correct or not. Because i already tried with Diversity, Primary and Secondary.
Joined: 06 Jun 2006 Posts: 7492 Location: Dresden, Germany
Posted: Wed Feb 25, 2009 18:48 Post subject:
for external antenna usage you must switch to secondary and you must also turn the small switch beside the antenna connector. _________________ "So you tried to use the computer and it started smoking? Sounds like a Mac to me.." - Louis Rossmann https://www.youtube.com/watch?v=eL_5YDRWqGE&t=60s
Posted: Fri Feb 27, 2009 16:29 Post subject: EXT- Antenna Usage
BrainSlayer wrote:
for external antenna usage you must switch to secondary and you must also turn the small switch beside the antenna connector.
It doesn't show any improvement with the settings it's looks like the directional antenna is working but the ext connect to 8dbi and 12dbi omni just producing the same results we do try with shorter sma cable.
Got firmware glitch on these?
Here few screenshots correct me if i made any settings wrong here
I try many settings here nothing improvement
Like extended range and etc
I try to change the transmit power to 27dbm m 28dbm and even 30dbm it still shows at 25dbm
1st think of the reg dom USA and the max allowed eirp. then the anennas gain is subtracted from the set tx power.
1st set antenna gain = 0 and check the max output power
Hi there tq for ur reply pls suggest me the name the country which i can go the up to 600mW.So many country to choose, don't want to test one by one. I hope dd-wrt doesn't limit the transmit power in the Country selection.